Tii 751-1T-01 Bedienungsanleitung PDF herunterladen

RJ11 OUTPUT

CONNECTOR

AUTOJACK

SLIDER

DOOR

REMOVABLE TOP

COVER TO ACCESS

IDC CONNECTIONS

UNTRIMMED WIRING

EXITING HOLES

P/N 92233501 • Rev B• 11/23/2009

Warranty: If this unit fails during the warranty period, contact tii customer service to authorize return. Unit may be returned prepaid.

Model 751-1T-01

Indoor Baseboard Jack

Installation Note

Description

1. The TII 751-1T-01 is an Indoor Network

demarcation point device suitable for multi

dwelling units. When installed at the service

entry point phone outlet, the unit provides

access to the telephone company’s central

office signals while disconnecting the inside

premises wiring. This is accomplished by

accessing the test jack identified on the front

of each unit. A “full-time” phone jack is also

provided on each unit so that a telephone

connection may be established at the location.

The unit is equipped with a half-ringer test

circuit for remote testing.

2. The TII 751-1T-01 is a surface mount unit

which may be mounted to a wall surface.

Features

Installation

GeneralNotice:

1. Installation of the TII 751-1T-01 must be in

accordance with the local Codes and Article

800 of the National Electric Code, ANSI/NFPA

70.

2. The TII 751-1T-01 is intended for indoor use.

3. In a typical installation the TII 751-1T-01 is

installed ahead of all telephone connections

inside the customer premises. The unit must

be installed at the point of service wire entry.

All customer premises wiring is then fed from

the TII 751-1T-01 Baseboard Jack.

InstallingtheBaseboardJack:

1. Detach the cover from the base by depressing

the finger grips located on both sides of the

cover. Pull the cover away from the base.

2. Identify and isolate the incoming telephone

company wires from the customer premises

wiring.

3. Install the tip and ring wires from the

telephone company into the IDC rocker

(marked “IN”). Do not strip the wires. Pull up

the IDC rocker to the fully open position &

insert the Telco wires until they bottom out

(See Figure 1).

4. Push down the IDC rocker to the closed

position for termination. See Figure 2 for the

TII 751-1T-01 wiring.

5. Install the inside customer premises wiring into

the IDC rocker (marked “OUT”). Do not strip

the wires. Pull up the IDC rocker to the fully

open position & insert the customer premise

wires until they bottom out (See Figure 1).

1 2

Installation Note 1

Inhaltsverzeichnis

Seite 1 - Installation Note

RJ11 OUTPUT CONNECTOR AUTOJACK SLIDER DOOR REMOVABLE TOP COVER TO ACCESS IDC CONNECTIONS UNTRIMMED WIRING EXITING HOLESP/N 92233501 • Rev B• 11/23/200

Seite 2

6. Push down the IDC rocker to the closed position for termination. See Figure 2 for the TII 751-1T-01 wiring. 7. If the customer premise wiring is

Kommentare zu diesen Handbüchern

Keine Kommentare

Tii 751-1T-01 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Ausrüstung Tii 751-1T-01 herunter. Tii 751-1T-01 User Manual [cs] [de] [en] [pl] Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Tii 751-1T-01